Identificador persistente para citar o vincular este elemento: http://hdl.handle.net/10553/69929
Título: Fluoride removal from natural volcanic underground water by an electrocoagulation process: Parametric and cost evaluations
Autores/as: Mena, V. F. 
Betancor-Abreu, A.
González, S. 
Delgado, S. 
Souto, R. M.
Santana, J. J. 
Clasificación UNESCO: 3303 ingeniería y tecnología químicas
Palabras clave: Aluminum Electrodes
Electrocoagulation Process
Fluoride Removal
Water Treatment
Fecha de publicación: 2019
Publicación seriada: Journal of Environmental Management 
Resumen: Excessive fluoride content in groundwater can cause serious risks to human health, and sources of groundwater intended for human consumption should be treated to reduce fluoride concentrations down to acceptable levels. In the particular case of the island of Tenerife (Canary Islands, Spain), the water supply comes mainly from aquifers of volcanic origin with a high content of fluorides that make them unacceptable for human consumption without prior conditioning treatment. The treatments that generate a high rejection of water are not acceptable because water is a scarce natural resource of high value. An electrocoagulation process was investigated as a method to treat natural groundwater from volcanic soils containing a hazardously high fluoride content. The operating parameters of an electrocoagulation reactor model with parallel plate aluminum electrodes were optimized for batch and continuous flow operations. In the case of the batch operation, acidification of the water improved the removal efficiency of fluoride, which was the highest at pH 3. However, operation at the natural pH of the water achieved elimination efficiencies between 82 and 92%, depending on the applied current density. An optimum current density of 5 mA/cm2 was found in terms of maximum removal efficiency, and the kinetics of fluoride removal conformed to pseudo-second-order kinetics. In the continuous-flow operation, with the optimal residence time of 10 min and a separation of 0.5 cm between the electrodes, it was observed that the current density that would be applied would depend on the initial concentration of fluoride in the raw water. Thus, an initial fluoride concentration of 6.02 mg/L required a current density >7.5 mA/cm2 to comply with the legal guidelines in the product water, while for an initial concentration of 8.98 mg/L, the optimal current density was 10 mA/cm2. Under these operating conditions, the electrocoagulation process was able to reduce the fluoride concentration of natural groundwater to below 1.5 mg/L according to WHO guidelines with an operating cost between 0.20 and 0.26 €/m3 of treated water.
URI: http://hdl.handle.net/10553/69929
ISSN: 0301-4797
DOI: 10.1016/j.jenvman.2019.05.147
Fuente: Journal of Environmental Management[ISSN 0301-4797],v. 246, p. 472-483
Colección:Artículos
Vista completa

Citas SCOPUSTM   

52
actualizado el 24-mar-2024

Citas de WEB OF SCIENCETM
Citations

44
actualizado el 25-feb-2024

Visitas

100
actualizado el 24-feb-2024

Google ScholarTM

Verifica

Altmetric


Comparte



Exporta metadatos



Los elementos en ULPGC accedaCRIS están protegidos por derechos de autor con todos los derechos reservados, a menos que se indique lo contrario.