Identificador persistente para citar o vincular este elemento: http://hdl.handle.net/10553/53009
Título: Uses of scanning electrochemical microscopy for the characterization of thin inhibitor films on reactive metals: The protection of copper surfaces by benzotriazole
Autores/as: Izquierdo, Javier
Souto, Ricardo M. 
Santana, Juan José 
González, Sergio
Clasificación UNESCO: 3303 ingeniería y tecnología químicas
3306 Ingeniería y tecnología eléctricas
Palabras clave: Corrosion inhibition
Copper
Benzotriazole
Scanning electrochemical microscopy
Fecha de publicación: 2010
Editor/a: 0013-4686
Publicación seriada: Electrochimica acta 
Resumen: Scanning electrochemical microscopy (SECM) was used to study the film formation of benzotriazole towards corrosion of copper. SECM was operated in the feedback mode by using ferrocene–methanol as redox mediator, and the sample was left unbiased at all times to freely attain its open circuit potential in the test environment. Following exposure to aggressive electrolytes the anticorrosion abilities of the layers were characterized by image analysis and by an electrochemical method derived from the experimental approach curves. Changes in the shape of the approach curves were clearly observed during the inhibitor film formation process. They showed the transition from an active conducting behaviour towards ferrocinium reoxidation typical of unprotected copper, to a surface exhibiting insulating characteristics when the metal was covered by a surface film containing the inhibitor. This supports that SECM is a practical technique in the investigation of corrosion inhibitor performance. However, a consistent tendency for the characterization of inhibitor film formation using SECM measurements in the positive feedback mode for the copper-benzotriazole system was only found if the experiments were conducted when the inhibitor molecule was not present in the test solution. That is, inhibitor molecules were found to interact not only with the copper surface during the monitoring process, but with the SECM tip as well, this effect being significantly enhanced when chloride ions were present in the electrolyte. Finally, a procedure to image the chemical activity of copper surfaces partially covered with the inhibitor film with SECM is proposed.
URI: http://hdl.handle.net/10553/53009
ISSN: 0013-4686
DOI: 10.1016/j.electacta.2010.08.020
Fuente: Electrochimica Acta[ISSN 0013-4686],v. 55 (28), p. 8791-8800
Colección:Artículos
Vista completa

Google ScholarTM

Verifica

Altmetric


Comparte



Exporta metadatos



Los elementos en ULPGC accedaCRIS están protegidos por derechos de autor con todos los derechos reservados, a menos que se indique lo contrario.