Please use this identifier to cite or link to this item:
http://hdl.handle.net/10553/135472
Title: | A 2-18 GHz 360° Phase Detector based on Switched Dual Multipliers and Fixed Delay Lines | Authors: | Dorta Naranjo, Blas Pablo Araña Pulido, Víctor Alexis Cabrera Almeida, Francisco José Jiménez Yguacel, Eugenio |
Keywords: | 360° dual multiplier phase detector | amplitude measurement | analog phase detector | calibrated RF array measurements | phase shift measurement | Issue Date: | 2025 | Project: | Demostrador Del Sistema Multiestratégico de Radiocomunicación Entre Dronesy Sensores en Grandes Terrenos Abruptosy Boscosos | Journal: | IEEE Transactions on Instrumentation and Measurement | Abstract: | This paper presents a 360º phase detector in the 2-18 GHz frequency band (160% relative bandwidth) that uses a fixed delay line as a phase shifter and a double multiplication, in-phase and out-of-phase, between the input signals. Initially, several classic 90º power splitter designs are analyzed under the new perspective that they can be used when integrated in this type of topology, where it is not necessary to comply with the quadrature condition. Simulations show increases of up to 600% of the relative bandwidth, going from a typical value of 20% (9-11 GHz) in branchline coupler structures, to 140% (3-17 GHz). It is slightly lower in those that use a Schiffman phase shifter (325%), where it goes from 40% (8-12 GHz) to 170% (1.5-18.5 GHz). This is followed by the design of the phase detector, with the main innovation being the use of a fixed delay line that can easily be implemented in other frequencies and technologies, and which presents a theoretical phase shift of 90±72º between 2 GHz and 18 GHz. The prototype is intended to show the possibilities of the design and the conceptual idea. In order to be part of a measurement array, the circuit has a cell-type topology. It features four switches that prevent the use of power dividers and line crossover, which facilitates its implementation in other frequencies and technologies, but increases the measurement time. Phase errors derived from the measurement system and amplitude noise at the multiplier output are analyzed. The measurement system uses a procedure based on quasi-synchronized generators, which guarantees a measurement error of less than ±3º. The manufactured prototype shows a deviation of quadrature of β=±72º in the 3 GHz to 18 GHz range, but at the 2 GHz frequency it displays a value of β=73º which considerably increases the phase errors compared to noise in the output voltages of the multiplier. The errors stay below ±5º in the 4 to 18 GHz band when considering an amplitude variation of ±7.5 mV (±1.5 ADC voltage resolution) in the output voltages of the multiplier, yet they increase to ±7º y [+6.5º -10.5º] at 3 GHz and at 2 GHz, respectively. The error decreases below ±1.5º between 4 and 17 GHz for a variation of ±2.5 mV (±0.5 ADC voltage resolution), increasing to ±2.3º at 18 GHz, ±3.3º at 3 GHz and ±4.6º at 2 GHz. | URI: | http://hdl.handle.net/10553/135472 | ISSN: | 0018-9456 | DOI: | 10.1109/TIM.2024.3522336 | Source: | IEEE Transactions on Instrumentation and Measurement[ISSN 0018-9456], (Enero 2024) |
Appears in Collections: | Artículos |
Items in accedaCRIS are protected by copyright, with all rights reserved, unless otherwise indicated.