Please use this identifier to cite or link to this item: http://hdl.handle.net/10553/128248
Title: Use of Pressure in Rotational Molding to Reduce Cycle Times: Comparison of the Thermomechanical Behavior of Rotomolded Reed/Polyethylene Composites
Authors: Ortega Medina, Zaida Cristina 
Suárez, Luis 
Kelly-Walley, Jake
Hanna, Paul R.
McCourt, Mark
Millar, Bronagh
UNESCO Clasification: 331005 Ingeniería de procesos
Keywords: Rotomolding
Cycle time reduction
Pressure
Energy consumption
DMA, et al
Issue Date: 2024
Journal: Journal Of Composites Science 
Abstract: Rotational molding advantages include the production of a hollow part with no welding lines, either of small or big sizes, with no internal stresses and good surface details. However, the process is limited by the long cycle times, and its related high energy consumption. Different strategies can be followed to reduce such energy use. This work assesses the use of pressure inside the molds during the densification and cooling stages, finding reductions in overall cycle time of approximately 20%, because of the reduction in the heating time required but also to the increased cooling rate. The influence of such an approach on the production of composites with reed fibers has also been assessed, finding a similar trend towards cycle time reductions. The rotomolded samples’ thermomechanical and rheological behavior were determined, finding that viscosity was not affected due to the incorporation of air during the moldings; besides, the homogeneity of the composites increased due to the mold pressurization. The parts obtained show good aesthetics and good thermomechanical behavior along the entire temperature range studied, and particularly for 10% composites; higher fiber ratios should be prepared via melt compounding. Therefore, the mold pressurization allows us to reduce both oven and cooling times, which can be translated into an increase in productivity and a decrease in energy consumption, which are undeniably related to the increase in the products’ sustainability and cost.
URI: http://hdl.handle.net/10553/128248
ISSN: 2504-477X
DOI: 10.3390/jcs8010017
Source: Journal of Composites Science [EISSN 2504-477X], v. 8 (1), 17, (Enero 2024)
Appears in Collections:Artículos
Adobe PDF (3,04 MB)
Show full item record

Google ScholarTM

Check

Altmetric


Share



Export metadata



Items in accedaCRIS are protected by copyright, with all rights reserved, unless otherwise indicated.